Fakra extension cable set for GPS 3.5 m with 2 adapters GT5 and GT16

Can Bus -steering wheel interface for remote control of the most important functions of a radio, such as volume up, volume down, search function forward, search function back, mute (mute) and source (source selection) if available in the vehicle and supported by the respective radio brand. These 6 buttons are located on the back of the steering wheel, 3 on top of each other on the right and left side of the steering wheel. The telephone buttons on the front side of the steering wheel are also supported by this solution, if they are also supported by the radio protocol.

At the interface are still the following cables, which are connected as follows:
Speed: cable color pink
Handbrake: cable color green
For these functions the longer pink cable must be additionally pinned to the fuse box as described in the manual.

Reverse signal: cable color violet
For this function, the loose violet cable must additionally be pinned to the fuse box, as described in the instructions.

Only for vehicles with so-called camp preparation, i.e. for vehicles without radio ex works!

Important note: Please note that the gray 6-pin connector of the interface in the vehicle may only be connected to the also gray connector and not to the orange connector.

The interface is delivered with a plug & play cable set for the main functions. Some cables must be connected to the fuse box as described above.

For the following vehicles :

FIAT:
Ducato 8 (model year 2022-)

For the interface a radio specific adapter cable is still needed:

ALPINE (69001)
BLAUPUNKT (69002) (2-DIN devices from approx. 2015 except series 990)
KENWOOD (69005)
PIONEER, AUDIOVOX, DYNAVIN, MAC AUDIO (69021)
SONY (69006)
ZENEC (69029)

or universal cable 69111

Note: This interface supports only the above radio brands. The use of the universal cable 69111 is only possible for the above mentioned brands.



*************************************************************************************************
Angaben zur Produktsicherheit/GPSR:
Marke/Trademark: Dietz
Hersteller/Manufacturer: Audiotechnik Dietz Vertriebs-GmbH, Maybachstr. 10, 67269 Grünstadt,
www.dietz.biz, verkauf@dietz.biz
*************************************************************************************************

For branded devices that only require an opening of 98 x 172.5 mm. With metal brackets and screws. Double DIN facia adapter for the new FIAT DUCATO, model year 2022.

Dimensions of the facia adapter:

Largest width visible: 245 mm (top)
Largest width with retaining lugs: 281 mm
Largest height visible: 159 mm
Difference to other solutions, such as 13550 or 13552:
Most double DIN radios are mounted as follows, e.g. for 13500 and 13552:
1. mounting of the plastic facia adapter.
2. insert the sheet metal basket into the plastic cover from the front and fix it by bending over various tabs.
3. Install the metal clips supplied with the metal basket on the side of the radio.
4. Push the radio into the metal basket from the front until the metal clips snap into place.
5. Cover the gap between the radio front and the plastic cover with the cover frame supplied with the metal basket.

In the case of the 60144 panel shown here, the radio is mounted from behind against the panel and finally installed in the dashboard together with the plastic panel.
This eliminates the need for the inner cover of the facia adapter as described in item 5 above and makes the installation look a bit more shapely.
Please note that this is possible with most branded radios if you have the taper in the front to 98 x 172.5 mm. Some so-called Chinese radios do not have this taper.


*************************************************************************************************
Angaben zur Produktsicherheit/GPSR:
Marke/Trademark: Dietz
Hersteller/Manufacturer: Audiotechnik Dietz Vertriebs-GmbH, Maybachstr. 10, 67269 Grünstadt,
www.dietz.biz, verkauf@dietz.biz
*************************************************************************************************

TIP:
The Flybat 100 Ah battery comes in the DIN box of the 80 Ah AGM battery. This means that the cases are absoultely the same size and the AGM battery can simply be replaced by the 100 Ah lithium battery. An AGM battery can usually only be discharged up to 50%, because then the critical voltage of 10.5 volts is reached. The 100 Ah lithium battery, on the other hand, can be discharged almost completely. The exchange results in a capacity increase by a factor of 2.25. (40 Ah AGM to approx. 90 Ah lithium).

Electrical Specifications:
- Nominal Voltage: 12.8V
- Nominal Capacity: 100Ah
- Capacity @ 25A: 240min
- Energy: 1280Wh
- Resistance: 30mOhm
- Efficiency: 99%
- Self Discharge: <3% per Month
- Maximum Modules in Series/parallel: 4/4

Mechanical Specifications:
- Dimensions (LxWxH) 318mm x 175mm x 188mm
- Weight: 13.5kg
- Terminal Type: T1
- Terminal Torque: 9-11 N-m
- Case Material: ABS
- Enclosure Protection: IP56
- Chemistry: LiFePO4

Temperature Specifications:
- Discharge Temperature: -20 to 60°C
- Charge Temperature: 0 to 55°C
- Storage Temperature: -20 to 60°C
- PCM High Temperature Cut-Off: 80°C

Charge Specifications:
- Recommended Charge Current: 50A
- Maximum Charge Current: 100A
- Recommended Charge Voltage: 14.2V - 14.6V
- PCM Charge Voltage Cut-Off: 15.6V
- Reconnect Voltage: 15.2V
- Balancing Voltage: 14.4V

Discharge Specifications:
- Maximum Continuous Discharge Current: 100A
- Peak Discharge Current: 200A
- PCM Discharge Current Cut-Off: 280A (±50A)
- Recommended Low Voltage Disconnect: 11V
- PCM Discharge Voltage Cut-Off: 8V
- Reconnect Voltage: 9.2V
- Short Circuit Protection: Yes

Advantages of FLYBAT lithium iron phosphate (LiFePO4) batteries:
- 5 year manufacturer's warranty
- The safest technology, without the risk of fire or explosion
- Integrated BMS
- Long service life
- 99% efficient
- High stability even under extreme load
- No memory effect- no need for full charge and discharge cycles
- High performance even under extreme conditions
- Deep and steady discharge and charging efficiency
- Small size and light weight

For winter operation, please see the information sheet:
"FLYBAT Winter Operation.pdf".

*************************************************************************************************
Product safety information:
Brand: Flybat
Manufacturer: BVD GmbH, Riedacker 5, 74889 Sinsheim , bvd@bvd-batterien.de
*************************************************************************************************