Cable gland with screw connection, i=29/38 mm

The antenna A10 is, according to our tests, at the moment the best antenna for optimal radio reception in camper van. The electronics, the antenna radiator and the antenna supports are perfectly matched to each other. For vehicles where the height does not matter, we always recommend the 23 cm antenna radiator. You will be thrilled!

Delivery contents:

Antenna A10
Antenna support 4, stainless steel 360*360*1,5 mm, painted white central hole d= 20 mm
Lowloss cable 7,5 m, Fakra socket - Fakra socket, for VHF
Adapter 1: Fakra plug - DIN plug
Adapter 2: Fakra plug - ISO plug

Lowloss cable 7,5 m, Fakra female - SMB female, for DAB+

Roof antenna with the following features:
- 16V antenna with long rod, length approx. 23cm
- DAB+ reception, active and low noise in the BAND 3
- VHF/FM/AM reception, active and low noise
- 12 Volt power supply via external cable 0,75 mm2 (no phantom power possible)
- low installation depth (approx. 15 mm)
- gain: FM: 9 dB
- Gain: DAB+: 14 dB
- power supply: 12 Volt, 30mA
- cable: RG 174, FM 300 mm, Fakra plug, white, code B
- Cable: RG 174, DAB+ 300 mm, Fakra plug, gray, code G

Low-Loss cables (...low loss cables) are the cables with the best electrical properties for lossless transmission of antenna signals. Our lowloss cable series has best conductance values and therefore lowest cable resistance. They are achieved by using tinned strands for the inner conductor (7*d=0,25mm), for the shield (42*d=0,11mm) and an additional aluminum foil between the PE dielectric and the shield. Only high quality Fakra plugs and sockets from Rosenberger are used. They have excellent workmanship and fit due to a special punching-bending technology of Rosenberger(Fakra-SF).

Technical data:

Characteristic impedance: 50 Ohm
Capacitance: 95pF/m
Extended POLYTHEN insulation 2.00 mm
Aluminum foil shielding and additional tinned copper braiding
Outer diameter: 3.6 mm

Note: This set replaces the previous sets:

A1T4L750UNI

DEKALIN adhesive set

- paintable
- wide adhesion spectrum
- very good UV and ageing resistance

The adhesive set is ideally suited for bonding solar modules, roof feed-throughs, antenna supports and metal plates to improve antenna reception characteristics.

Delivery contents:

- 290 ml adhesive, white
- Decavator 30 ml
- Cleaning cloth set (moist/dry)
- brush
- Instruction manual

You will find gluing instructions under the tab "Documents".

The technical data sheets and the safety data sheets for individual components of the set can be found here under the tab "Documents".

Hazard statements for the decavator:
H225 Highly flammable liquid and vapour
H315 Causes skin irritation
H318 Causes serious eye damage
H361d Suspected of damaging the unborn child
H336 May cause drowsiness and dizziness
H304 May be fatal if swallowed and enters airways
H411 Toxic to aquatic life with long lasting effects.
For experienced users only.

The antenna A2 is according to our tests, the best antenna at the moment for optimal radio reception in motor homes. The electronics, the antenna radiator and the antenna supports are perfectly matched to each other. You will be thrilled! In addition, the antenna is equipped with GPS and GPS Glonass and thus supports the future-oriented European GPS system.

Delivery contents:

Antenna A2
Antenna support 4, stainless steel 360*360*1.5 mm, painted white
Central hole d= 20 mm
2 pcs. mounting bracket stainless steel 360*50*35 mm, white painted
6 stainless steel screws
Waterproof junction box 15933, pre-drilled with 38 mm for mounting under the central borehole
Lowloss cable 10m, Fakra socket - Fakra socket (B-coding, white)
Adapter 1: Fakra plug - DIN plug, for VHF (B-coding, white)
Adapter 2: Fakra plug - ISO plug, for VHF (B-coding, white)

Lowloss cable 10 m, Fakra socket - SMB socket , for DAB+ (G-coding, grey)

GPS cable 10 m, Fakra socket - Fakra socket (C-coding, blue)
Adapter 3: Fakra plug - GT5 socket (for e.g. Alpine, Kenwood, Clarion), (C-coding, blue)
Adapter 4: Fakra plug - GT16 socket (f. Pioneer), (C-coding, blue)

Roof antenna with the following features:

- DAB reception, active and low noise in BAND 3 and L (passive)
- VHF/FM/AM reception, active and low-noise
- Active GPS antenna
- 12 volt power supply either via inner conductor of the cable connections (phantom power) or via DIN socket (see picture)
- low-noise antenna rod
- low installation depth (approx. 15 mm)
- Gain: FM: 14 dB
- Gain: AM: 6dB
- Gain: DAB+: 10 dB
- Gain: GPS/Glonass: 28 dB
- Power supply: 12 Volt, 25mA
- Cable: RG 174, AM/FM 110 mm, Fakra plug, white
- Cable: RG 174, DAB+ 200 mm, Fakra plug, grey
- Cable: RG 174, GPS 150 mm, Fakra plug, blue

Low loss cables are the cables with the best electrical properties for the lossless transmission of antenna signals. Our lowloss cable series has best conductivity values and therefore lowest cable resistances. They are achieved by using tinned strands for the inner conductor (7*d=0,25mm), for the shield (42*d=0,11mm) and an additional aluminum foil between the PE dielectric and the shield. Only high quality Fakra plugs and sockets from Rosenberger are used. They have an excellent finish and fit due to a special punch-bend technology of the Rosenberger company(Fakra-SF).

Technical data:

Characteristic impedance: 50 Ohm
Capacity: 95pF/m
Extended POLYTHEN insulation 2.00 mm
Aluminium foil shielding and additional
tinned copper braid Outer diameter: 3.6 mm

Note: This set replaces the previous sets:
A2T4L1000DIN
A2T4L1000DYN